I liked a few of the VSOs that were posted earlier and wanted to share two of my more recent creations.
This mount screws into an exposed 2x4 and lets me get my Synology DS418, its power brick, and UPS (APC BE600M1) off a table and into a lower dust area of my basement.
I’ll upload the STLs to printables if anyone is interested, but be warned that the parts are fairly large.
In the spirit of showing parts under unflattering lighting, here’s (nearly) the same angle with a different light source.
This scares the hell out of me. Too much risk of damage. Heat, weight, and time.
There’s basically no heat involved. It sounds like you’re worried about creap, which is totally fair and something to be aware of. The parts are printed out of ASA and are very overbuilt, so there shouldn’t be any cause for concern.
Creap video: https://youtu.be/88pk2cNOeGE?si=_JxBtYyYitBEin2Y
Here is an alternative Piped link(s):
https://piped.video/88pk2cNOeGE?si=_JxBtYyYitBEin2Y
Piped is a privacy-respecting open-source alternative frontend to YouTube.
I’m open-source; check me out at GitHub.
I’d print it but using ABS
It’s ASA, it’ll be fine :)
Yeah. That’ll be good.
It looks beefy enough to me