• 1 Post
  • 13 Comments
Joined 1 year ago
cake
Cake day: July 2nd, 2023

help-circle










  • Thanks for the input!
    So the thing I was trying to print was this: https://www.thingiverse.com/thing:6365845
    Ideally you’d just print it in PLA but I only had one colour PLA so I thought, might as well gather some PETG printing experience :D
    The part in question is red_panda_low_poly_V1_-_head_A_red.STL and I tried to print it on an odd angle to make sure that most of the outwards facing walls were on the top, because anything that needed support turned out so hideous.

    Also it seems to appear on any side of the model, where you have a slight overhanging angle, in no particular axis :)

    I’ll print it in pla once my current print is done :D




  • Hey, not sure how in depth your linux/docker knowledge is. Please disregard if irrelevant. I would recommend you pick a fixed mountpoint for the drive and set up a systemd service to mount the drive for you (systemd .mount file). Then you add an extra line “RequiredBy=docker.service” (look for systemd RequiredBy) This way the drive always has to be mounted by the system before docker is started and should always be visible before you start a container.

    Hope this helps :)