It was out of mind until I got this new build plate with a fancy texture that I want to imprint on my prints.
It was out of mind until I got this new build plate with a fancy texture that I want to imprint on my prints.
This is PLA, I can’t get PETG to stick to the “PEO” bed plate.
Thanks, now I’m hungry
I tried adjusting the z offset to raise the nozzle, but it didn’t help.
My bl-touch mount broke so I’ve been doing manual bed leveling for a while. I just finished printing a 185x185mm part (half of a dactyl keyboard) and the first layer looked great from the top.
Edit: I also deleted the old bed mesh from my klipper config when the bl-touch broke
40/200 looks the same as 60/220. I can try 60/210 but I don’t think it will be any different.
It’s hot - 60 bed, 220 nozzle. I’ll try 40/200
Layer adhesion is great.
No, this pattern isn’t coming from the bed. The bed actually has a polygon pattern that I’m trying to get the plastic to pick up. Sellers on Amazon/ebay/Ali are calling it PEO, but it’s really just PEI with a fine texture that diffracts light. The pattern from the bed comes through really well on the perimeter of anything I print, but not the center.
I forgot to mention, but I also played with the extrusion multiplier (both directions) and it didn’t make a difference. I’ve also gone through the klipper docs and TeachingTech’s calibration guide, the printer is fairly well calibrated at this point.
Again, I’m just guessing wildly, but anything which scares people away from smoking is good in my opinion.
That’s where I disagree, spreading misinformation as scientific fact causes people to lose trust in health authorities, and it fuels things like the anti-vax movement and flat earthers. The ends don’t justify the means.
If I misunderstood your post, it wasn’t intentional. Would you mind elaborating?
Either way there are a lot more contexts where one can use slut and not be shitty.
True, but I don’t think that’s the case here.
There’s no “punching down”, unlike with the antiquated ‘R’ word…
Women can’t be “punched down” on? News to me…
Sex shaming is fun?
A lot of that was exaggerated. 7 minutes per puff really doesn’t sound realistic. But since it convinced people to stop smoking I guess everyone agreed it was OK?
7 minutes per puff? Who says that?
There aren’t any alternatives that follow the RPi’s original mission, they’re all for-profit. And I’m not sure you’ll find a more affordable board than the $15 Pi Zero 2.
I’m not sure I fully understood, but it sounds like you have several concerns with their competition? And those concerns are around asking people to design things that are potentially unsafe, giving bad advice for selecting materials, and awarding prize money to submissions by Prusa employees?
They are fundamentally different types of vehicles. But putting that aside, if you want to compare the largest payload that each vehicle can transport you wouldn’t just use the pickup truck’s GVWR, you would also include it’s towing capacity. There’s a reason 90% of the time people use a pickup to haul something, they’re towing.
This is why we can directly compare the two vehicles payload capacity.
No, comparing a zeppelin with a pickup will never be a direct comparison.
I tried printing a disk with the bed at 70c and it looks better. Going to try with it even higher. This sheet has a +0.350 z offset compared to my normal PEI sheet, so that might contribute to low heat conduction.