• sygnius@lemmy.world
    link
    fedilink
    English
    arrow-up
    0
    ·
    1 year ago

    There’s a risk that if you try to turn the square cover that the cover will fall into the hole. It’s really strange that it’s square and not round.

        • Hyperreality@kbin.social
          link
          fedilink
          arrow-up
          0
          ·
          1 year ago

          Depends. The cover is resting on the inside lip which prevents moisture getting in. Ie. this cover is actually significantly bigger than the hole it’s covering.

          Eg. if this cover is 25x25, but it’s covering a hole which is less than 18x18 (c=25.5), it’ll be quite hard to drop the cover in.

          • sygnius@lemmy.world
            link
            fedilink
            English
            arrow-up
            0
            ·
            1 year ago

            I think you’re misunderstanding. Yes, it cannot fit in when it’s angled properly to fit into the hole. However, if you angle the plate 45 degrees and lift one end of the plate, it will fall into the diagonally. That’s why manholes are round shaped. There is no angle for a round cover to fall into the hole itself.

    • Hyperreality@kbin.social
      link
      fedilink
      arrow-up
      0
      ·
      1 year ago

      It’s really strange that it’s square and not round.

      It’s not even slightly strange. These are incredibly common all across Europe and the world.

      It’s a small cover, almost certainly to service the nearby drainpipe or perhaps for the water or gas connection to a house.

      The chance of it falling in the hole is zero unless you’re trying to do it on purpose. Lift and slide, done.

      And even if it does fall in, you can simply reach in and pull it out.

    • ZephrC@lemm.ee
      link
      fedilink
      English
      arrow-up
      0
      ·
      1 year ago

      I’m pretty sure the reason is that the hole isn’t deep enough for it to matter. That’s nowhere near big enough to be a manhole.