Whether you’re really passionate about RPC, MQTT, Matrix or Nostr, tell us more about the protocols or open standards you have strong opinions on!
Whether you’re really passionate about RPC, MQTT, Matrix or Nostr, tell us more about the protocols or open standards you have strong opinions on!
NAT is also good security wise. Personally I’d rather the inside of my network stay completely anonymous
You can have that with ipv6, too.
NAT is not for security, that’s what the firewall is for. Nobody can access your IPv6 network unless you allow access through the firewall.
I don’t think they were talking about access to the network.
“The inside of the network stay anonymous” sounds like they are talking about internet access to the internal network.
If computers connect to others through the internet, the IPv6 address can reveal how many computers there are on the local network, and if certain traffic to different destinations are coming from the same computer, but also if one of the computers has gone offline but then resumes from sleep/hibernation.
To me their comment means they want to avoid that, and I agree, I want to avoid that too. To fix these, I would need to configure NAT on my router for IPv6.
Yes IPv6 address privacy extensions help somewhat, but
With v4 addresses these did not really matter, because everything was being sent from the same public IP, and and outside observer could only see what a “network” is doing collectively. But with v6 an address identifies a computer, across websites/services. Even if it’s just for a "short’ time, even if the address is randomized.
If you want privacy, you need some kind of VPN or onion routing. Even if everything you list were correct, the difference between IPv4 and 6 for privacy would be marginal.
Found the guy that does not want to learn IPv6!
You’re thinking of a firewall. NAT is just the thing that makes a connection appear to come from an IP on the internet when it’s really coming from your router, and it’s not needed with IPv6. But you would not see any difference with IPv6 without it.
That connection only “appears to come from” if I explicitly put a rule in my NAT table directing it to my computer behind the router doing the NAT-ing.
Otherwise all connections through NAT are started from internal->external network requests and the state table in NAT keeps track of which internal IP is talking to which external IP and directs traffic as necessary.
So OP is correct, it does apply a measure of security. Port scanning someone behind NAT isn’t possible, you just end up port scanning their crappy NAT router provided by their ISP unless they have specifically opened up some ports and directed them to their internal IP address.
Compare this to IPV6 where you get a slice of the public address space to place your devices in and they are all directly addressable. In that case your crappy ISP router also is a “proper” firewall. Strangely enough it usually is a “stateful” firewall with default deny-all rules that tracks network connections and looks and performs almost exactly like the NAT version, just without address translation.
You end up just port scanning their crappy router on IPv6 as well because ports that are not opened are stuck at the firewall either way, no matter if you use IPv4 or IPv6.
Just because every device gets a public IP does not mean that IP is publicly accessible.
An advantage that IPv6 has against port scanning is the absurdly large network sizes. For example, my ISP gives me a /56 prefix, that is 4,722,366,482,869,645,213,696 IPv6 addresses. Good luck finding the used ones with the port open you need.
Even with just a /64 prefix you get 18,446,744,073,709,551,616 addresses, way outside the feasibility of port scanning.
No. Stop spreading that myth. NAT does fuck all for security. If you want a border gateway, you can just have a border gateway.