I have an Ender 3 S1 that I use every couple of months at this point because it’s just such a pain to use. I have to adjust the bed tramming and z offset and run auto bed leveling for every single print and often times that’s still not good enough.
It will often take 30+ minutes just to get the first layer going down successfully.
Is this a me problem or did I lose the creality lottery?
I bought a X1C and have never leveled it once. Everything is completely automatic, and I’ve never had a failed print.
If I can see that the print quality is starting to go down (and by that I mean I can see a little ringing or something), I just hit the calibrate button and it does everything on its own with zero intervention besides the initial button.