I have an Ender 3 S1 that I use every couple of months at this point because it’s just such a pain to use. I have to adjust the bed tramming and z offset and run auto bed leveling for every single print and often times that’s still not good enough.

It will often take 30+ minutes just to get the first layer going down successfully.

Is this a me problem or did I lose the creality lottery?

  • huginn@feddit.itEnglish
    0·
    8 months ago

    I will go months between prints on my prusa and then print back to back for several days.

    I haven’t leveled my bed since 2021 but still get perfect first layers.