In my efforts to kill this engine I’ve started to design a few bits to slap a small charger on, this was the easy bit, but also I got it right on the first print, which is rare for me.
You must log in or # to comment.
Looks sick! And even sicker that it’s on a motorcycle!
Sounds like fun, good luck!
There are reasons why they don’t make these out of plastic.
I’d run it for the prototype, just for funsies, until a shop can make the real part or the plastic breaks. It might last longer than you think.
It’s a test fit part, jlccnc will make the final piece out of 6061
No idea what they are trying to achieve outside of the “trying to kill this engine” part. I’m just hoping for the video of what goes wrong. (Hopefully not one of someone getting injured)
I’ve a very small 2 lobe pump, it’ll pump extra air into the engine, make extra power and hopefully some nice noises.
Cheap engines make for fun toys, I’m surpized I haven’t kill it so far anyway.
