I would really appreciate it if someone could help me with this. I’m having an issue with my Sovol SV06, which is that I get a lot of stringing. I’m still fairly new to 3D printing, so I have no idea what could cause this and how I could go about fixing this. I already searched for this issue online btw but didn’t really find anything helpful.

The only change I made to this printer is that I hooked up a Raspberry Pi 4 to it and installed Klipper and Octoprint. I’m also using PrusaSlicer with the config from here.

    • Fisch@discuss.tchncs.deOP
      link
      fedilink
      English
      arrow-up
      0
      ·
      4 months ago
      • Material: PLA
      • Brand: GEEETECH
      • Nozzle Temp: 215°C
      • Nozzle size: 0.4 mm
      • Retraction speed: 40 mm/s
      • infinitevalence@discuss.online
        link
        fedilink
        English
        arrow-up
        0
        ·
        4 months ago

        215c is probably too high for PLA

        Maybe try out a Temp Tower and see where the sweetspot is on your stuff.

        I run mostly Pollymaker PLA and I find the best prints at 190c.

        • Fisch@discuss.tchncs.deOP
          link
          fedilink
          English
          arrow-up
          0
          ·
          edit-2
          4 months ago

          I could try a lower temperature but I don’t know what a temp tower is

          Edit: I just looked up what a temp tower is, makes sense to try that in general to find the optimal temperature