I see, from the original post you say most of these guys are PETG, how are they holding up? From what I can see there isn’t much difference between then and now, well your plants are much larger of course
PETG is holding up fine. Both these and the couple I printed last year are still going strong. ABS is good as well.
PLA is brittle, but gets the job done. I wouldn’t recommend this material for something you want outside more than 3-4 years (at least with my weather).
Surprised to hear the PLA is holding up. I had a small print in my car for about 3 weeks before it warped beyond recognition, but that was a pretty thin flat print so it makes sense.
What kind of print settings were these done with, if you remember? Nozzle size, wall count, infill is mainly what I’m curious about. Working on some projects and want the parts to be strong but don’t want to use unnecessary amount of filament
My angle is probably a bit different.
I see, from the original post you say most of these guys are PETG, how are they holding up? From what I can see there isn’t much difference between then and now, well your plants are much larger of course
PETG is holding up fine. Both these and the couple I printed last year are still going strong. ABS is good as well. PLA is brittle, but gets the job done. I wouldn’t recommend this material for something you want outside more than 3-4 years (at least with my weather).
Surprised to hear the PLA is holding up. I had a small print in my car for about 3 weeks before it warped beyond recognition, but that was a pretty thin flat print so it makes sense.
What kind of print settings were these done with, if you remember? Nozzle size, wall count, infill is mainly what I’m curious about. Working on some projects and want the parts to be strong but don’t want to use unnecessary amount of filament