I am not a design draftsman, I’m not an engineer. My workflow is usually: I put something on the scanner, load the calibrated scan, trace the outline, throw a few sketches on various planes in there, round a few edges, print it and I’m done.

Fusion 360 scratches that itch very well but requires me to keep a Windows VM and also their free model felt more and more unusable. OnShape is a nice substitute that works fine for me, but I don’t like the “free or 1500€/year” approach. Without a middle ground subscription for makers it feels that I could lose anything the second their energy prices for servers go up or something.

The list of CAD software is exhaustive, so I am looking for recommendations that fit my “eh, click, click, click, good enough” workflow. FreeCAD is way too unintiuitive for that. I have tried getting into it, but 3D printing is a tool for me and the learning curve quickly made using it another hobby.

So. Suggestions welcome. Scalding criticism about my lack of enthusiasm and consumer mentality not so much, but I guess that comes bundled with useful advice, so, eh, I’ll take it.

  • Kraiden@kbin.run
    0·
    4 months ago

    it looks like Fusion 360 runs fine on Linux

    I can assure you, it does not.

    Do not switch to Linux and expect this project to save you, it is NOT beginner friendly.

    It’s great, and I’m sure someone smarter than me could probably get it working, but personally, I failed miserably and switched to OnShape.

    • wjrii@lemmy.worldEnglish
      0·
      4 months ago

      Yup. At this point, “locally installed, reliable, parametric modeling on Linux” = “FreeCAD, including Ondsel, and SolveSpace”. That’s it. Well, there’s code-to-CAD as well, which obviously retains parametric history, but goes about it very differently than a design tree.

      For non-parametric modeling, BricsCAD and Plasticity enter the discussion. For parametric on the web, OnShape works very well but I hate their licensing scheme and the huge doughnut hole in their pricing model.

      • fulg@lemmy.worldEnglish
        0·
        4 months ago

        I was quite amazed reading NopHead’s blog a while back because he uses OpenSCAD exclusively, even managing to design an entire printer and its upgrades in there. I didn’t think any sane person could do this.

    • fulg@lemmy.worldEnglish
      0·
      4 months ago

      I should have prefaced that I did not actually run this myself, but I did take a note of it, it looked promising. Sorry for the false hope!

      I would expect it to work after a lot of fussing about, and then break at the slightest update. Easier to run it in a VM (which is also not easy in order to get GPU acceleration without dedicating a card to it - I never managed to get Intel GVT-g nor GVT-d to work reliably).