Finally upgraded my resin printer to having a flex bed and my only regret is not doing it sooner
I also finished upgrading my printing enclosures to using 8in ducting for ventilation. This combined with the 8in fan I’m using puts the ventilation at cycling the entire air contents of my room every 2 minutes at the highest setting or once every 4 minutes at the fan setting I use.
To do the upgrade required me to print a 8in duct splitter because buying one is prohibitively expensive.
What the adapter looks like
I started the migration of my NAS to a new system but that’s going to finish (hopefully) by Friday. The data has been duplicated I just have to wait a bit as a piece of software I need to install on one of the VMs has its key locked until Friday (can’t be activated on a new system) and that piece of software is currently installed on the system that will become my new NAS.
Pretty great
Finally upgraded my resin printer to having a flex bed and my only regret is not doing it sooner
I also finished upgrading my printing enclosures to using 8in ducting for ventilation. This combined with the 8in fan I’m using puts the ventilation at cycling the entire air contents of my room every 2 minutes at the highest setting or once every 4 minutes at the fan setting I use.
To do the upgrade required me to print a 8in duct splitter because buying one is prohibitively expensive.
What the adapter looks like
I started the migration of my NAS to a new system but that’s going to finish (hopefully) by Friday. The data has been duplicated I just have to wait a bit as a piece of software I need to install on one of the VMs has its key locked until Friday (can’t be activated on a new system) and that piece of software is currently installed on the system that will become my new NAS.
Edit: rendered the clip at a lower res