cm0002@lemmy.world to 3DPrinting@lemmy.worldEnglish · 2 days agoPrintGuard Is a New Open Source 3D Printing Failure Detector That Runs on the Edgewww.hackster.ioexternal-linkmessage-square14fedilinkarrow-up11arrow-down10
arrow-up11arrow-down1external-linkPrintGuard Is a New Open Source 3D Printing Failure Detector That Runs on the Edgewww.hackster.iocm0002@lemmy.world to 3DPrinting@lemmy.worldEnglish · 2 days agomessage-square14fedilink
minus-squareAppearanceBoring9229@sh.itjust.workslinkfedilinkEnglisharrow-up0·2 days agoDown anyone know of it works with belt printers? I had it, but it kept restarting some prints that were fine and never detected a failure :(
minus-squarenickwitha_k (he/him)@lemmy.sdf.orglinkfedilinkEnglisharrow-up0·23 hours agoMy suspicion would be that belt printers were not in the scope when writing it. Probably a good idea to open an issue in GitHub so that they can fix it.
Down anyone know of it works with belt printers? I had it, but it kept restarting some prints that were fine and never detected a failure :(
My suspicion would be that belt printers were not in the scope when writing it. Probably a good idea to open an issue in GitHub so that they can fix it.